Setting the Configuration Data
To use , you should have a file in your ~/.config (or in $XDG_CONFIG_HOME, if set) directory called kdesrc-buildrc, which sets the general options and specifies the modules you would like to download and build.
It is possible to use different configuration files for , which is described in . If you need to use multiple configurations, please see that section. Here, we will assume that the configuration is stored in ~/.config/kdesrc-buildrc.
The easiest way to proceed is to use the kdesrc-buildrc-kf5-sample file as a template, changing global options to match your wants, and also change the list of modules you want to build.
The default settings should be appropriate to perform a build. Some settings that you may wish to alter include:
install-dir, which changes the destination directory that your software is installed to. This defaults to ~/kde/usr, which is a single-user installation.
branch-group, which can be used to choose the appropriate branch of development for the modules as a whole. There are many supported build configurations but you will likely want to choose kf5-qt5 so that downloads the latest code based on 5 and Frameworks 5.
will use a default branch group if you do not choose one, but this default will change over time, so it's better to choose one so that the branch group does not change unexpectedly.
source-dir, to control the directory uses for downloading the source code, running the build process, and saving logs. This defaults to ~/kde/src.
cmake-options, which sets the options to pass to the command when building each module. Typically this is used to set between debug or release builds, to enable (or disable) optional features, or to pass information to the build process about the location of required libraries.
make-options, which sets the options used when actually running the make command to build each module (once has established the build system).
The most typical option is -jN, where N should be replaced with the maximum number of compile jobs you wish to allow. A higher number (up to the number of logical CPUs your system has available) leads to quicker builds, but requires more system resources.
sets the option num-cores to the detected number of available processing cores. You can use this value in your own configuration file to avoid having to set it manually.

Configuring Make to use all available CPUs, with exceptions

global
    # This environment variable is automatically used by make, including
    # make commands not run by kdesrc-build directly, such as Qt's configure
    set-env MAKEFLAGS -j${num-cores}
    …
end global

…

module-set big-module-set
    repository kde-projects
    use-modules calligra
    make-options -j2 # Reduced number of build jobs for just these modules
end module-set

Some very large Git repositories may swamp your system if you try to compile with a too many build jobs at one time, especially repositories like the WebKit and WebEngine repositories. To maintain system interactivity you may have to reduce the number of build jobs for specific modules.
Configuring Make to use all available CPUs, with exceptions gives an example of how to do this.
You may want to select different modules to build, which is described in .