pam_debug.so
[
auth=value
] [
cred=value
] [
acct=value
] [
prechauthtok=value
] [
chauthtok=value
] [
auth=value
] [
open_session=value
] [
close_session=value
]
The pam_debug PAM module is intended as a debugging aide for determining how the PAM stack is operating. This module returns what its module arguments tell it to return.
auth=value
The
pam_sm_authenticate(3) function will return
value
.
cred=value
The
pam_sm_setcred(3) function will return
value
.
acct=value
The
pam_sm_acct_mgmt(3) function will return
value
.
prechauthtok=value
The
pam_sm_chauthtok(3) function will return
value
if the
PAM_PRELIM_CHECK flag is set.
chauthtok=value
The
pam_sm_chauthtok(3) function will return
value
if the
PAM_PRELIM_CHECK flag is
not set.
open_session=value
The
pam_sm_open_session(3) function will return
value
.
close_session=value
The
pam_sm_close_session(3) function will return
value
.
Where value
can be one of: success,
open_err, symbol_err, service_err, system_err, buf_err, perm_denied,
auth_err, cred_insufficient, authinfo_unavail, user_unknown,
maxtries, new_authtok_reqd, acct_expired, session_err, cred_unavail,
cred_expired, cred_err, no_module_data, conv_err, authtok_err,
authtok_recover_err, authtok_lock_busy, authtok_disable_aging,
try_again, ignore, abort, authtok_expired, module_unknown,
bad_item, conv_again, incomplete.
Default return code if no other value was specified, else specified return value.
auth requisite pam_permit.so auth [success=2 default=ok] pam_debug.so auth=perm_denied cred=success auth [default=reset] pam_debug.so auth=success cred=perm_denied auth [success=done default=die] pam_debug.so auth optional pam_debug.so auth=perm_denied cred=perm_denied auth sufficient pam_debug.so auth=success cred=success